Samsung WF45T6000AW – Troubleshooting Checkpoints Before Calling a Technician (Includes Manual)
Before spending money on technician visits, it’s essentional to go through a few simple yet critical checkpoints that are often overlooked. If you own the Samsung WF45T6000AW washing machine and it’s not working as expected — whether it’s not starting, draining, or completing the cycle — there’s a good chance the issue can be resolved with a basic pre-check. This guide highlights the most essential steps you should take before calling for service.
These checkpoints are designed to help you troubleshoot smarter, save time, and avoid unnecessary repair costs. For your convenience, the official user manual is available below, providng in-depth guidance, detailed settings instructions, and comprehensive explanations of erroe codes specific to this model.
Key Troubleshooting Checkpoints for the Samsung WF45T6000AW
Now that you’re ready to inspect your washer more closely, use the following checklist to address the most common problems reported by Samsung WF45T6000AW owners. These checkpoints are based directly on Samsung’s official recommendations and are rewritten here in simple, easy-to-follow language, helping you take action confidently without technical stress.
Whether your washer won’t start, isn’t draining, vibrates too much, or shows signs of water issues, each of these checks could be the simple fix you need.
If the Washer Doesn’t Start:
- Confirm the washer is plugged into a working power outlet
- Ensure the door is fully shut and latched
- Press and hold the Start/Pause button to begin the cycle.
- Check that Child Lock is turned off
- Make sure both water faucets are fully open
- Listen for clicking sounds — it’s normal while checking the door lock.
- Reset your circuit breaker or check the fuse if needed
If Water Isn’t Flowing In:
- Both water supply faucets must be fully open
- Make sure the hoses aren’t kinked, frozen, or clogged
- Confirm proper water pressure in your home
- Close the door completely to start water intake
If Detergent Remains After the Cycle:
- Ensure sufficient water pressure is available
- Use liquid detergent in the correct container
- Remove the liquid insert if using powdered detergent
- Clean the detergent drawer regularly
If You Hear Excessive Noise or Vibration:
- The washer must be on a flat, stable surface
- Remove all shipping bolts if not done already
- Balance the laundry load properly inside the drum
- Check for metal objects like coins or zippers
- Slight noise from the motor is normal during operation
If the Washer Isn’t Draining or Spinning:
- Make sure the drain hose isn’t clogged or frozen
- Clean the drain pump filter
- Confirm that the door is fully closed
- Ensure the washer is getting uninterrupted power
- Check if the drain hose is 6–8 inches into the pipe
If the Door Doesn’t Open:
- Wait 1–3 minutes after the cycle ends (lock delay is normal)
- Ensure the drum is fully drained
- Restart the unit and turn off the Child Lock
- If power is lost mid-cycle, plug back in and hold Start/Pause
Source: Patrick Duyck / Youtube
If Water Temperature Feels Wrong:
- Open both hot and cold taps fully
- Verify that hoses are correctly connected to hot/cold taps
- Clean mesh filters on inlet hoses
- Automatic temperature control may adjust the water mix — that’s normal
Other Quick Fixes:
| Problem | Quick Action |
| Washer stops mid-cycle | Check the power, press Start again, and clean the mesh filter. |
| Excess suds | Use only HE detergent, and in small amounts. |
| The washer leaks water | Tighten hose connections, avoid overloading. |
| Has odor | Clean the drum, door seal, and run Self-Clean regularly. |
| The load stays wet | Use High spin speed, check the drain hose, and avoid small loads. |